57 GMC 496 Canyon Carver - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Nut Case · 03-20-2018, 03:15 AM

Walls framed, trusses up and squareD and sheeted and shingled. Exterior walls have been water proofed with poly plastic. Windows and man door installed. Caulking the walls where ever there is a sheeting butt joint in the sheeting, doing HU 1 truss anchors. Lots of chalking to stop drafts.

Then on to drilling for the rough electrical, pull cable make up boxes, then get C of O.

Ill try to load photos the next time I up date. hoping for better weather, but since Iam a one man show, it takes what ever time it takes.

An tips on the electrical system for what ever would be welcome.

Keep on Keepin on

Nut Case

03-20-2018, 03:15 AM	#31
Nut Case Registered User Join Date: Jul 2014 Location: Clear and Still Idaho Posts: 509	Re: 57 GMC 496 Canyon Carver Walls framed, trusses up and squareD and sheeted and shingled. Exterior walls have been water proofed with poly plastic. Windows and man door installed. Caulking the walls where ever there is a sheeting butt joint in the sheeting, doing HU 1 truss anchors. Lots of chalking to stop drafts. Then on to drilling for the rough electrical, pull cable make up boxes, then get C of O. Ill try to load photos the next time I up date. hoping for better weather, but since Iam a one man show, it takes what ever time it takes. An tips on the electrical system for what ever would be welcome. Keep on Keepin on Nut Case __________________ Been there, wrecked that

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.