Reproduction Rubber Floor Mat

[Killer Bee]

just got mine in yesterday and posted in the progress thread;

http://67-72chevytrucks.com/vboard/s...&postcount=644

the truck shop mat went down pretty easy and most of the holes lined up with the impressions on the back..

especially pleased how well it sits in there since I dropped it right on the bare floor without tar or foam or anything yet..

$10 harbor freight gasket punch kit is probably spent, but did the trick for the mat and the seat..

even cleaned up all of the original pedal pads.. wd40 and steel toothbrush to clean and stand up a little fur to cut the gloss..

de-greased with 409 to get that squeaky, non-slip finish back..

my 6yo took some of these while I was trimming and fitting..