|
05-12-2004, 03:56 PM
|
#1 |
|
Keepin an eye out
Join Date: Feb 2003
Location: So.Cal
Posts: 3,921
|
Horn needs fixing...
At board suggestions I replaced the horn relay. Put power to the horns(2) themselfs but only one works. Do they both need to work to complete the circuit? I have a grant steering wheel and everythings there. I need some troubleshooting suggestions....thanks.
__________________
1970 Chevy C10 SWB 5.3 1996 Toyota Tacoma SR5 4x4 2007 Vespa GTS 250 Scooter ZIP 91351 |
|
|
|
05-12-2004, 05:00 PM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
no they dont both have to work to complete a circuit, first thin to do is unbolt both from the rad support and take sandpaper to the mountin surfaces to assure the proper ground
the next thing is GRANT STEERING WHEELS=HORN DON'T WORK in about 95.37294%of the time
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
05-12-2004, 06:15 PM
|
#3 |
|
Keepin an eye out
Join Date: Feb 2003
Location: So.Cal
Posts: 3,921
|
I will check the horn grounds. It is more than the steering wheel as I can ground the wire and get nothing.
__________________
1970 Chevy C10 SWB 5.3 1996 Toyota Tacoma SR5 4x4 2007 Vespa GTS 250 Scooter ZIP 91351 |
|
|
|
|
05-12-2004, 08:16 PM
|
#4 |
|
20' Daredevil (Ret)
 
Join Date: May 2003
Location: Jefferson State
Posts: 13,694
|
Some horn basics - in case you don't already know
 . Steering wheel horn button sends ground to the horn relay, which you can hear clicking as it operates & releases. Horn relay sends 12vdc to horns, which will work if (a) they are good, and (b) they have a good ground - via the mounting bolt, to frame ground.
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
|
|
05-13-2004, 01:47 AM
|
#5 |
|
My other Love
Join Date: Aug 2001
Location: Castlegar B.C. Canada
Posts: 4,085
|
there is a set screw on the horns themselves you can turn the screw clockwise to make the contacts work inside again, chances are the ground wire is broken off in the column, ground out the relay and see if they honk, then you will know where the problem lies
__________________
 Castlegar B.C.The great white North (Canada Eh!) Hooter_5@hotmail.com First generation Monte Carlo club pictures of my life |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
