![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Aug 2017
Location: Independence MO
Posts: 11
|
Laminated circuit plug question
I’m getting no juice to the plug wires 1&12 that feed into the laminated circuit and in turn feed the amp meter/ voltmeter can somebody tell me where they originate? Alternator, coil? I don’t know thanks for your help
Posted via Mobile Device |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Nov 2009
Location: Sherman, ME
Posts: 2,359
|
Re: Laminated circuit plug question
The wire from pin #1 originates at the truck's main power distribution point, which is a multi-wire factory splice located inside the wiring harness near the voltage regulator. The wire from pin #12 originates at the junction block on the passenger side fender near the battery.
Both of these wires are protected by 4 Amp inline fuses located near the origination points. The factory fuse holders (if still in place) look like this: |
![]() |
![]() |
![]() |
#3 | |
Proprietor of Dale's Corner
![]() Join Date: Nov 2012
Location: Vacaville , CA
Posts: 16,103
|
Re: Laminated circuit plug question
Quote:
__________________
"Some Days Chickens And Some Days Feathers" Dale XNGH ECV Sam Brannan 1004 R.I.P. 67ChevyRedneck R.I.P. Grumpy Old Man |
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Aug 2017
Location: Independence MO
Posts: 11
|
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|