![]() |
|
![]() |
#1 |
Senior Member
![]() Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: windshield install
i would like to know how it goes, Did you by a windshield sealant from CR Laurence?
I had mine installed a few years ago and then it rained the next week , I went out side and my whole dash was full of water. took it back after it dried out and they went back and sealed it
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks ![]() |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Apr 2008
Location: Md
Posts: 2,485
|
Re: windshield install
1/4" is probably too big, handles not needed, 4" piece of broom stick or pvc pipe if you need it couple loops close to where your working. Nylon tool set and hook set from Harbor freight would help...little plastic pry bars etc....dish liguid water tape.....Tape off any paint you want to keep nice.. Urethane caulk up in the corners after its all together
__________________
http://67-72chevytrucks.com/vboard/s...d.php?t=635605 |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|