|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-01-2004, 01:08 PM
|
#1 |
|
The Blazer King
Join Date: Sep 2000
Location: Valrico, Fl (Tampa)
Posts: 1,212
|
Proper Rally Lug Nuts?
Anyone know what the proper size and style of lug nut should be used? These are 5 lug Truck rally's.
__________________
72 2wd Blazer. Its the superbichinest, megacoolinest, superflowinest. |
|
|
|
06-01-2004, 01:43 PM
|
#2 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
they are 1/2" 20 thread, & the steel wheels have a 60 degree taper on the seat. I dont know if correct, or not but they look good....i got a set of acorn style chrome nuts at Advanced auto parts($28 for lugs & locks). crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
06-02-2004, 04:32 PM
|
#3 |
|
The Blazer King
Join Date: Sep 2000
Location: Valrico, Fl (Tampa)
Posts: 1,212
|
Anyone else? Just want to make sure I get the correct ones put my rally's on and not have to drive to the parts store 6 times. :p Wanna make sure they are closed end and will go all the way over the studs too. If someone had a pic too. That would be great.
__________________
72 2wd Blazer. Its the superbichinest, megacoolinest, superflowinest. |
|
|
|
|
06-02-2004, 06:51 PM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
As I remember, the studs were about 1 " long.....just be sure to have 1 1/8 - 1 1/4" depth inside the closed end lug nuts ,so you dont bottom out before tightening, & you should do fine. I didnt opt to run the lock nuts with the kit, so I picked up an extra 4 pack of nuts. they will be listed for steel wheels. crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
