|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-20-2019, 06:34 PM
|
#1 |
|
Registered User
Join Date: May 2009
Location: Hazel Green AL
Posts: 286
|
Holes stripped out on lower moulding. What to put in them to tighten them up?
I am trying to secure my moulding's alittle more. The 2 screws that hold the back of the lower side moulding behind the rear wheel are stripped out. What can i put in the stripped out metal to make them hold again? Are do i need to try to get larger screws?
|
|
|
|
06-20-2019, 06:38 PM
|
#2 |
|
Registered User
Join Date: Aug 2009
Location: Bowser
Posts: 13,707
|
Re: Holes stripped out on lower moulding. What to put in them to tighten them up?
You could try using a thin piece of wire. Poke it into the hole and put the screw in.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
