|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-03-2004, 11:14 PM
|
#1 |
|
Registered User
Join Date: Dec 2003
Location: albuquerque
Posts: 431
|
Need help with drive shaft after engine/tranny swap
Well I finally swapped out the original v6/3-speed in my 68 gmc lwb to a 350/350 combo. The engine is located in the forward position and the tranny has the shorter 6" tail shaft. Now to the problem, I went to install my fron drive shaft and discovered that it is about 3" inches to short. If anyone has done a similar swap how much was needed to be added to to the driveshaft length? Or was the yoke from a similar setup longer? Or was there a front driveshaft made specifically for the v8/350 combo that is longer? If so does anyone have a length that I should be looking for? I could go rummage around one of the local yards and see what I find...
thanks. |
|
|
|
06-04-2004, 07:28 AM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
you just need a new driveshaft for a v8 auto setup , try the parts board i'm sure guys got them cheap
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
