Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
08-20-2019, 08:52 PM | #1 |
Registered User
Join Date: Feb 2007
Location: Blairsville, PA
Posts: 301
|
Keeping sun visors from falling down
I got a new set of sun visor brackets and visors from Classic Industries, and they are fine, but somewhere I read what to do to put tension on the visor so it stays up, but can't remember what it was. Any suggestions? Tbrown
__________________
tbrown's 56 Cameo Build |
08-20-2019, 10:23 PM | #2 |
Registered User
Join Date: Sep 2014
Location: USA
Posts: 2,249
|
Re: Keeping sun visors from falling down
I've bought a couple of sets of reproduction sun visors, and never had an issue with them flopping down, usually the opposite - they've all been TOO stiff and too hard to move.
__________________
1951 Chevy Panel Truck |
08-21-2019, 03:21 AM | #3 |
Registered User
Join Date: Sep 2014
Location: USA
Posts: 2,249
|
Re: Keeping sun visors from falling down
Found this tip on LMC visor page:
http://www.lmctruck.com/features/ca/CACI3.htm Sun Visor Installation Tip: If your sun visor is loose on the rod and won't stay in the up position, bend the rod slightly to tighten the sun visor on the rod.
__________________
1951 Chevy Panel Truck |
08-21-2019, 07:58 AM | #4 |
Registered User
Join Date: Feb 2007
Location: Blairsville, PA
Posts: 301
|
Re: Keeping sun visors from falling down
Thanks MiraclePieCo, I will give that a try.
__________________
tbrown's 56 Cameo Build |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|