|
10-07-2019, 09:25 PM
|
#1 |
|
Registered User
Join Date: Sep 2019
Location: Tulsa OK
Posts: 2
|
Vertically challenged
Hello, was hoping to get some input from folks that has had this same problem and was successful in some way. Or if you know of a previous thread that would help please send my way.
I’m 57, 6’4” and recently purchased a ‘68 C10. Much to surprise the cab is smaller than I remember. What I am hoping to find out is what you did to create more leg room or more room in general, even if it was just an illusion. Did you shave down seat foam, replace seat with another...install a tilt column...adjust pedal placement etc? I apologize if I’m beating a dead horse. |
|
|
|
10-07-2019, 10:18 PM
|
#2 |
|
Special Order
  
Join Date: Nov 2004
Location: Mt Airy, MD
Posts: 85,852
|
Re: Vertically challenged
You can move the steering column closer to the dash by collapsing the lower shaft a bit. Another thing is chop down the seat brackets or make others that set the seat lower. I'm sure seat adjustment is no needed, just mount as far back as possible.
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~ |
|
|
|
|
10-07-2019, 10:25 PM
|
#3 | |
|
Proprietor of Dale's Corner
 
Join Date: Nov 2012
Location: Vacaville , CA
Posts: 16,242
|
Re: Vertically challenged
Quote:
__________________
"Some Days Chickens And Some Days Feathers" Dale XNGH ECV Sam Brannan 1004 R.I.P. 67ChevyRedneck R.I.P. Grumpy Old Man R.I.P. FleetsidePaul |
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
