Cgt project - The 1947 - Present Chevrolet & GMC Truck Message Board Network

vet57air · 03-20-2020, 09:39 PM

Quote:

Originally Posted by SCOTI

That's about spot on where mine is & I share the same concern of it being tucked too much. The issue w/trimming the inner bedside flange is you can't trim much (maybe .675?). Even @ that, I would want to reinforce it somehow. I am still contemplating possibilities....

What wheel widths did you ultimately purchase?

Front wheels are 9" with a 255/35/22. Turns lock to lock no issues at ride height (coil overs). Rears are 12" 325/35/22

vet57air · 03-20-2020, 09:43 PM

Put it on the ground today and rolled it out. The rear tire looks better sitting on the ground.
[ATTACH] Name: 90.jpg
Views: 835
Size: 50.9 KB

[/ATTACH]

vet57air · 04-01-2020, 08:14 PM

Most of the fab. is done. Starting to take apart to paint. These are the nine pieces that make up my exhaust.
Name: exhaust.jpg
Views: 770
Size: 46.1 KB

SCOTI · 04-02-2020, 07:02 PM

Quote:

Originally Posted by vet57air

Put it on the ground today and rolled it out. The rear tire looks better sitting on the ground.

Love it. Stance = nailed.

03-20-2020, 09:43 PM	#2
vet57air Registered User Join Date: Oct 2018 Location: B.C. Canada Posts: 206	Re: Cgt project Put it on the ground today and rolled it out. The rear tire looks better sitting on the ground. [ATTACH][/ATTACH] Attached Images

04-01-2020, 08:14 PM	#3
vet57air Registered User Join Date: Oct 2018 Location: B.C. Canada Posts: 206	Re: Cgt project Most of the fab. is done. Starting to take apart to paint. These are the nine pieces that make up my exhaust.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.