|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-21-2004, 11:11 AM
|
#1 |
|
Before and After
Join Date: Feb 2000
Location: Leduc, Alberta CANADA
Posts: 632
|
HEI and Header Questions
I know that the swap for the HEI unit is a no-brainer, but will I have to recurve the unit for the engine that I am building?
Are the exhaust ports all the same on all Small blocks? even the Vortecs? Are there any sites that would give me info for the distributor question.
__________________
Not Grandpa's C-20 anymore... 383 Stroker 425HP, 485Ft/Lbs Lowered 3.5" Front / 5" Rear 66,000 miles. Alberta, CANADA |
|
|
|
06-21-2004, 03:01 PM
|
#2 |
|
Registered User
Join Date: Jan 2002
Location: Sahuarita, AZ USA
Posts: 2,033
|
HEI's are a drop in, nothing else to do (except make sure you aren't off a gear or something)
__________________
Bill - Tucson, AZ 47 Chevrolet 2 dr sedan 56 Chevrolet 210 2 dr sedan 66 Chevrolet Malibu 2 dr 4 speed 71 Chevrolet C30 Longhorn 86 Chevrolet Monte Carlo SS (Sold) 01 Chevrolet Tahoe IM - BUSTERWIVE@aol.com |
|
|
|
|
06-21-2004, 04:30 PM
|
#3 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
you do have to run a new power wire for an hei to eliminate the resistor wire as well as eliminate the yellow wire from the starter
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
06-21-2004, 07:03 PM
|
#4 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
i agree with both guys on the HEI, its a pretty bolt in swap, with addition of a wire from IGN unfused in the fuse box(full batt voltage). As far as a recurve, it will help your power band & mileage. Crane puts out a nice kit , vac advance can + springs for the mech advance.....the instruction is also good! It will take a little time 1st time around, but after a time or 2 , you will have a new "trick" that you can keep
 As far as ports & header match up, you should be ok for most apps.....if you try to run some monster heads , like a 12 or 18 degree (roundy pounder stuff), you will have issues with headers. Best of luck,crazyL 
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
