1970 C30 Car hauler Buildish thread.

[jarrodblake]

I made a set of motor mounts yesterday. I made them out of 1/2 and 1/4 plate.

IMAG2790 by jarrod vanwinkle, on Flickr

IMAG2791 by jarrod vanwinkle, on Flickr

IMAG2792 by jarrod vanwinkle, on Flickr

IMAG2793 by jarrod vanwinkle, on Flickr

I removed the block of wood I had spacing the engine from the crossmember.

IMAG2795 by jarrod vanwinkle, on Flickr

IMAG2794 by jarrod vanwinkle, on Flickr

Hopefully the master cylinder I plan on using is a bit shorter than this one. I know its taller Ideale I would use a 45 off the intake, but I may have to use a 90.

IMAG2797 by jarrod vanwinkle, on Flickr

IMAG2798 by jarrod vanwinkle, on Flickr

I wonder if there are any drive shaft shops open around me. Ideally I would just have them shorten it for me than replace it. If there is not one open near me I may end up shorting it myself.

IMAG2799 by jarrod vanwinkle, on Flickr

I made the transmission crossmember today out of scrap I cut off the bed of the truck.

IMAG2800 by jarrod vanwinkle, on Flickr

IMAG2801 by jarrod vanwinkle, on Flickr

IMAG2802 by jarrod vanwinkle, on Flickr

There were two 3/8 holes on each side of the frame in almost the perfect place.

IMAG2804 by jarrod vanwinkle, on Flickr

IMAG2803 by jarrod vanwinkle, on Flickr

IMAG2807 by jarrod vanwinkle, on Flickr

I wonder if I will be able to remove the rear valve cover without removing the trans crossmember.

IMAG2809 by jarrod vanwinkle, on Flickr