Cab and Doors, New Floors and Rockers

[ljbear]

I have a 1970 non A/C cab I'm just finishing for sale. The floors and rockers are new, the rest was still very good. The heater and clutch openings have been welded up, so it set up for Vintage Air or and Old Air system. Dash is uncut. Corners had a small spot on each side, about the size of a quarter, that were cut out and new area welded in. The supports are solid. Still a few small dings, almost ready for primer. The doors are both nice, rust free and need very little. $500. As soon as I get all the panels welded in I'll get some pictures.

I'm going up to Vancouver around the 12th, so I can deliver along I-5 in NorCal, Oregon, or SW WA. I also have a bunch of other parts available that can get delivered along the way as well. Take a look at the Parts page in my signature. I'll have a smaller load heading back, so if you have parts that need a ride this way let me know, I can probably help get them as far as Sacramento.

[bad69]

Larry; where abouts in vancouver(my home town)I'm going on the 16th for 4 days,I would like that cab. If you still have it when you get back I'd like to see it as well as the 71-72 front clip.
mitch

[ljbear]

Mitch,

Not exactly sure yet , I'm picking up a blazer tub about 15 miles north of Vancouver. PM an email address and I'll send the pictures when I have them.

Larry

[Tahoe72]

PM'd you about a set of doors

[O'skool 72GMC]

I'm looking for a set of 72 doors. A cab and long bed would be nice too. And if you got all that how about the winning lotto numbers too

[ljbear]

bad69 sent you a pm about the doors.

Tahoe sent you a pm with information you requested.

O'skool, no 72 doors, but do have several other sets, 68-71