Hard Starting Hot

[Rich72C10]

Well, after a few days I can't seem to figure it out. So I created a video and sent the link to Quadrajet Power (Mark).

This is with their clip needle thingy removal and I have installed a check valve into the filter.

Truck has set ~10 hours and inside the garage it is 80 degrees. While I gave it two solid pumps in this video for this carburetor, my previous carburetor I only needed to tap it so the choke would close and fast idle would engage.

So what have I fudged up? If you are bored give the video a watch, its just under 2 minutes. At the beginning the carb is still as it was when I had shut it down 10 hours before. The video ends when I tap the pedal to come out of fast idle.


https://drive.google.com/file/d/1ws5...ew?usp=sharing