Boyd EFI Tank/Pump and Carburetor

[elorenzof]

I have a Boyds Under Bed Aluminum Tank With EFI fuel Pump. I also have a carbureted engine at this point. I'd like to put the tank in, and then save up for the Sniper EFI which will be in a few months. With all you peeps I'm hoping that someone could tell me how to run a few months with an EFI pump and a carburetor I'm sure there is a way? 1972 C10 350 Automatic 2WD The Boyd tank does have a Fuel return port.

[C101972]

I also am running the same fuel tank, I ran 3/8” feed and return lines. I plan on running the Hollow Terminator setup, but unfortunately it is not quite that far. Good luck on your build.
Posted via Mobile Device

[pjmoreland]

I've got a Boyd tank with EFI fuel pump to a carburetor. I installed a low-pressure Holley 12-881 regulator. Details can be found in the following thread. Check out post #24.

https://67-72chevytrucks.com/vboard/...d.php?t=828999

[Joyridin]

I have a carb insert for the Boyd tank if you need one.

[elorenzof]

Originally Posted by Joyridin

I have a carb insert for the Boyd tank if you need one.

I would like to purchase that from you if possible I will pm you.

[Joyridin]

Originally Posted by elorenzof

I would like to purchase that from you if possible I will pm you.

Let me know.