Doing LS Swap - I have no idea what I'm doing! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

EagleChief · 05-09-2022, 01:25 PM

TAC module is mounted up and pedal is hooked up. Now all I need is to finish my gas tank mount, run the fuel lines and regulator, get that all set up, and wire up the individual wires from the harness to the ignition and power. I still need to get a radiator, and possibly a trans cooler, and run the transmission lines. I think... if I have any of my fuel hose left, I'll see if there is enough of it to run the trans lines. It's AN-6 PTFE steel braided hose. It should be sufficient for the transmission lines, right?

05-09-2022, 01:25 PM	#21
EagleChief Registered User Join Date: Sep 2016 Location: Tulsa, OK Posts: 410	Re: Doing LS Swap - I have no idea what I'm doing! TAC module is mounted up and pedal is hooked up. Now all I need is to finish my gas tank mount, run the fuel lines and regulator, get that all set up, and wire up the individual wires from the harness to the ignition and power. I still need to get a radiator, and possibly a trans cooler, and run the transmission lines. I think... if I have any of my fuel hose left, I'll see if there is enough of it to run the trans lines. It's AN-6 PTFE steel braided hose. It should be sufficient for the transmission lines, right? __________________ 1971 C10 - Hugger Orange/White My Build Thread: http://67-72chevytrucks.com/vboard/s...d.php?t=780197 LS Swap Thread: https://67-72chevytrucks.com/vboard/...d.php?t=811460

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.