Need pulley help - The 1947 - Present Chevrolet & GMC Truck Message Board Network

skokie · 08-12-2004, 04:06 PM

I need to know if this is the correct way to setup the crank pulleys. Also what size bolt will need to go into the block? Is it 2 1/2?
Thanks

skokie · 08-12-2004, 07:03 PM

Got it figureed out.

Tx Firefighter · 08-12-2004, 07:23 PM

The flatter one goes on the back and the deeper dished one goes on top of it. They index on each other with the raised lip around the holes in the flatter one. Re-use your old bolts from your old long pulley setup.

08-12-2004, 04:06 PM	#1
skokie Registered User Join Date: Oct 2003 Location: San Jose Ca. Posts: 3,354	Need pulley help I need to know if this is the correct way to setup the crank pulleys. Also what size bolt will need to go into the block? Is it 2 1/2? Thanks Attached Images

08-12-2004, 07:23 PM	#3
Tx Firefighter Watch out for your cornhole ! Join Date: Jun 2003 Location: Azle, Texas Posts: 14,162	The flatter one goes on the back and the deeper dished one goes on top of it. They index on each other with the raised lip around the holes in the flatter one. Re-use your old bolts from your old long pulley setup. __________________ I'm on the Instagram- @Gearhead_Kevin

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-12-2004, 07:03 PM	#2
skokie Registered User Join Date: Oct 2003 Location: San Jose Ca. Posts: 3,354	Got it figureed out.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.