NJ Bolt size help needed for 67-68 Grille Support- Center

[NGN]

There are two small bolts that hold the grille center support, one each for the back of the top and bottom inserts of the grill, along with u-nuts they screw into. Mine were rusted and cut out, must of swept them up with the pile of rust . I looked through some catalogs with no luck. Happy New Year
Thanks
NGN
Nick

[Jason Banks]

I thought I had the sizes written down, but I only found this picture...Maybe this helps.

[Jason Banks]

I went to pull one out of my truck and found I didn't put them back. Found them in stuff I had plated.
#14 x 5/8

Like these - https://www.auveco.com/14-x-5-8-ind-...crew-zinc-2370

I think the j-nuts would be - https://www.auveco.com/j-nuts/j-nut-...040-range-2057 or https://www.auveco.com/j-nuts/j-nut-...nel-range-2420

One of the vendors has to have them in small qty.... I'm 99% sure I have bought them before.

[71CHEVYSHORTBED402]

Originally Posted by NGN

There are two small bolts that hold the grille center support, one each for the back of the top and bottom inserts of the grill, along with u-nuts they screw into. Mine were rusted and cut out, must of swept them up with the pile of rust . I looked through some catalogs with no luck. Happy New Year
Thanks
NGN
Nick

3/8” hex flange head tap screws and U-nuts. The screw threads are 1/4 x 5/8”. The U-nuts have a 3/8" center hole to edge.

[Getter-Done]

Originally Posted by 71CHEVYSHORTBED402

3/8” hex flange head tap screws and U-nuts. The screw threads are 1/4 x 5/8”. The U-nuts have a 3/8" center hole to edge.

Thanks
I was fix'in to walk out in the cold and try to measure mine.

[NGN]

Thanks you all for the very helpful info.
Happy New Year 🍻
NGN
Nick