|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-19-2004, 01:10 PM
|
#1 |
|
Mudslides 'r my specialty
Join Date: Dec 2003
Location: STL
Posts: 1,106
|
How do I reinstall the LCA bumpstop?
When I changed out my coil springs, I inadvertently pulled the bumpstop out of the lower control arm...I can't get it back in. I push, but it just "squishes."
I tried "lubing" it with silicon spray...didn't work. Can anyone help?
__________________
Always on the lookout for old cars and parts...(20s, 30s, 40s, 50s, 60s, etc.) http://www.cardomain.com/memberpage/500339 |
|
|
|
08-19-2004, 01:30 PM
|
#2 |
|
Registered User
Join Date: Feb 2004
Location: Hodgenville, Ky
Posts: 735
|
If I remember correctly, it fits into a slit in the control arm. You install it by sliding the retaining tab into the end of the slit (a wider cut in that location) and slip it in.
|
|
|
|
|
08-19-2004, 01:53 PM
|
#3 |
|
Mudslides 'r my specialty
Join Date: Dec 2003
Location: STL
Posts: 1,106
|
I don't remember seeing that, but I will look again. Thanks.
__________________
Always on the lookout for old cars and parts...(20s, 30s, 40s, 50s, 60s, etc.) http://www.cardomain.com/memberpage/500339 |
|
|
|
|
08-19-2004, 03:13 PM
|
#4 |
|
Registered User
Join Date: Feb 2004
Location: eastern blowville heights, ohio
Posts: 57
|
A little lubrication and a set of pliers gently working the rubber tab as it sticks through the LCA slot was sucessful for me.
Mike |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
