In desperate need of 62 c-10 axle

[Andrew 62]

The rear-end is the Dana with the drop out third member. Spline count is 17. Length from inside surface to end of the button is 29 5/8 , or 29 9/16. the length is real close due to the axle being in two pieces. Also the button on the end is the thick button. There were 2 styles. One was about an eighth inch thick and the other around 5/16. Six lugs for the lug nuts also.

[MOTHERTRUCKERS]

Do you need the small or large button? also what zipcode for shipping?

[jim walker]

Originally Posted by Andrew 62

The rear-end is the Dana with the drop out third member. Spline count is 17. Length from inside surface to end of the button is 29 5/8 , or 29 9/16. the length is real close due to the axle being in two pieces. Also the button on the end is the thick button. There were 2 styles. One was about an eighth inch thick and the other around 5/16. Six lugs for the lug nuts also.

I m comfused Axle in 2 pieces? 60 - 62 should be the same (1/2 ton with removable gear carrier aka third member, pumkin) and my 61 axles are 1 piece. Never heard of a 2 piece axle. Also, are you referring to the button end as the end that accepts the c clips? Just curious...