Gear pattern gurus…take a look

[kwmech]

Originally Posted by SilverGT3RS

Thank you for the reply! I ran the check with a drill because I’ve seen 3-4 supposed pros on YouTube doing it. You know how that goes though, everyone is a pro on there. LOL.



So, a tad deep meaning it needs a bit less shim? What are you thinking, .003-.004?

Yep, that's if you want to go through the trouble I'd pull 003 out of it. Personally I'd run with it as is. FWIW, I've been setting up diffs for over 40 years and never heard of spinning it with a drill. Frigg'n u toob

[SilverGT3RS]

Originally Posted by kwmech

Yep, that's if you want to go through the trouble I'd pull 003 out of it. Personally I'd run with it as is. FWIW, I've been setting up diffs for over 40 years and never heard of spinning it with a drill. Frigg'n u toob

I think I’m going to run as is for now. I appreciate you guys looking at it.