![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Oct 2008
Location: los angeles ca
Posts: 216
|
Thread chaser size for 1990 5.7 ltr. head bolts
Hello,
I am replacing my cylinder heads and was curious to know what size thread chaser I will need so I can clean out the thread bolt holes on the block. I did search this site, however, I cannot locate the information I need and do not have a thread pitch gauge to measure the head bolts Is it also acceptable to use a tap in place of a thread chaser? One other question, is there anyway to clean the cylinder walls without scratching them? When the head gasket blew, some coolant in one of my cylinders left a film on the cylinder wall. Thank you for any help. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Oct 2009
Location: .
Posts: 2,185
|
Re: Thread chaser size for 1990 5.7 ltr. head bolts
The thread size/pitch should be 7/16"x14tpi(threads per inch).
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Oct 2008
Location: los angeles ca
Posts: 216
|
Re: Thread chaser size for 1990 5.7 ltr. head bolts
Thank you for your help.
|
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|