The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Racing and high performance (trucks haulin more than hay)

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 12-28-2023, 06:48 PM   #1
litebulblsc
Registered User
 
litebulblsc's Avatar
 
Join Date: Aug 2006
Location: LaSalle Mi
Posts: 525
Rear gear ratio question

I am considering a different gear ratio for my truck. Currently has 3.73:1. Playing with an online calculator, I could go down to 4.56:1 and still be able to get to 135 mph in 3rd. My fastest trap was about 118 mph, and I can only add so much more power with my current setup, that I do not see me hitting 135 mph in the quarter.

So is there a reason not to go with the lower gear ratio? It should make the truck faster, correct? The only down side I can think of is traction,but their are ways to overcome that.
litebulblsc is offline   Reply With Quote
Old 12-29-2023, 12:10 AM   #2
Getter-Done
Senior Member
 
Getter-Done's Avatar
 
Join Date: Dec 2009
Location: TN.
Posts: 8,429
Re: Rear gear ratio question

You could go with a 5:14.

The math is there.
__________________
________________________________________________________________________________________
____________________________________________
84 Chevy K-20
63 Impala (my high school car)


http://67-72chevytrucks.com/vboard/s...Crew Cab Build
Getter-Done is offline   Reply With Quote
Old 12-30-2023, 08:41 AM   #3
regan wilson
Registered User
 
regan wilson's Avatar
 
Join Date: Mar 2008
Location: tyler texas
Posts: 1,538
Re: Rear gear ratio question

A lot of things come into play on choosing the right gear. Tire size, transmission gear ratios, tq converter slip, max rpm etc.
__________________
NHRA Super Street 469C
It only runs 10.90 at 156 mph
regan wilson is offline   Reply With Quote
Old 12-31-2023, 07:38 AM   #4
litebulblsc
Registered User
 
litebulblsc's Avatar
 
Join Date: Aug 2006
Location: LaSalle Mi
Posts: 525
Re: Rear gear ratio question

Quote:
Originally Posted by Getter-Done View Post
You could go with a 5:14.

The math is there.
I am aiming to up my mph some. That would put me at "redline" at the stripe with the convertor locked




Quote:
Originally Posted by regan wilson View Post
A lot of things come into play on choosing the right gear. Tire size, transmission gear ratios, tq converter slip, max rpm etc.
Tire is 29.5
Trans ratio would be 1:1
I have a lockup convertor, so slip could be zero
Max RPM is 7000

With those numbers it comes out to about 135 mph at 7000 rpm.
litebulblsc is offline   Reply With Quote
Old 01-08-2024, 05:24 PM   #5
68racer
Yeah baby!
 
68racer's Avatar
 
Join Date: Feb 2001
Location: United Kingdom
Posts: 436
Re: Rear gear ratio question

I calculated that changing from 3.7 to 4.1 would give me a tenth or two. It made no difference at all, although it became more consistent. These trucks hit aero problems at the top end.
__________________
11.37 @116
68racer is offline   Reply With Quote
Old 01-08-2024, 06:38 PM   #6
regan wilson
Registered User
 
regan wilson's Avatar
 
Join Date: Mar 2008
Location: tyler texas
Posts: 1,538
Re: Rear gear ratio question

I think 4.56 will work. Especially with the lockup converter.
__________________
NHRA Super Street 469C
It only runs 10.90 at 156 mph
regan wilson is offline   Reply With Quote
Old 01-08-2024, 10:47 PM   #7
Ziegelsteinfaust
Registered User
 
Join Date: Dec 2012
Location: Temple City
Posts: 3,633
Re: Rear gear ratio question

I run 4.88's daily with a Detroit locker in a 32" tire. Or a 285/65R17.

To me the biggest hold back of the combo is the TH700R4. If I had the money's to do over. A 4L80e would of been a more optimal choice.

Even though my engine is just a highly tuned gen2 LT1 it is a absolute blast to drive. I do miss the way bigger cam I had before. If I replace the cam it will be with a smog legal performance cam to get a little more out of her, but keep my drivibility.

My gear ratio, and Detroit effectively stop me from burning out. So that would be good for the 1/8 mile.

The same gear ratio hurts my top end charges a bit because my engine is more torquey vs 4500 rpm plus performance.

So with out mentioning engine specs or build list, and tire size.

Even 4.11's or 4.33's maybe a better split the difference overall combo.
Ziegelsteinfaust is offline   Reply With Quote
Old 01-09-2024, 01:28 PM   #8
litebulblsc
Registered User
 
litebulblsc's Avatar
 
Join Date: Aug 2006
Location: LaSalle Mi
Posts: 525
Re: Rear gear ratio question

I ordered the 4.56s and a detroit locker last week. Can't wait till the Spring to try them out.
litebulblsc is offline   Reply With Quote
Old 07-16-2024, 07:49 PM   #9
litebulblsc
Registered User
 
litebulblsc's Avatar
 
Join Date: Aug 2006
Location: LaSalle Mi
Posts: 525
Re: Rear gear ratio question

I can't get no tire traction. I can't get no tire traction. Cause I try and I try and I try and I try. I can't get no, I can't get no

That is the theme song of the truck now.
litebulblsc is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:51 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com