65 Fairlane pro-touring build

[62c30]

Originally Posted by Vic1947

Began scuffing the street side of the rear wheel wells and then applied a couple of coats of 3M rubberized undercoat. I did some rudimentary body work over the pie cuts before priming with epoxy but was still pleased to see how much evil the undercoat hides.

Which 3m undercoat did you use? I've seen several different ones. I was going to use raptor liner on some inner fenders but I'm thinking about undercoat instead.

[Vic1947]

Originally Posted by jaros44sr

Your metal skills are impressive. Wish I had a bead roller, or you were my neighbor

I agree - it's always great to have a like-minded neighbor. I bought my "Low Buck Tools" bead roller years ago and never regretted the purchase. Since then, I've modified it with a HF winch, so I don't have to ask Kathy to be my helper. It's a very handy tool for all sorts of metal shaping.

Originally Posted by 62c30

Which 3m undercoat did you use? I've seen several different ones. I was going to use raptor liner on some inner fenders but I'm thinking about undercoat instead.

I usually use the 3M 08964 Body Schutz, but it requires a special applicator gun and throwaway plastic tube. I ran across a deal for the 03584-aerosol version and decided to give it a try. I think the Body Schutz goes on thicker and is more durable, but neither product is as tough as Raptor or other bed liners. My goal was more cosmetic than durability, so the aerosol works okay in that regard.

[Vic1947]

The floor pan is finally assembled with SS rivets and 3M panel adhesive. The trans tunnel is held in place for the time being with clecos. I'm trying to decide whether to make it removeable. If I don't, Murphy's Law will make me regret it. I put all the rear suspension back in and set it up at ride height so I could measure the tire/wheel clearances. Looks like I'll be able to fit a 315/40-18 tire on an 11" rim and have plenty of room. Seam sealer is going on where panel assembly is complete.

[62c30]

Looks damn good!