|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-03-2024, 07:25 PM
|
#1 |
|
Junior Member
 
Join Date: Oct 2005
Location: Bakersfield, CA
Posts: 315
|
Front Leaf Top Rear Shackle Bushing Removal
I’m needing some help removing the bushings that are in the lower brackets of the cross member. This is the front leaf spring rear shackle top bushing that goes through the frame. The bracket is so close on one side and is in line with the bushing so I can’t use the press. It seems to be too close to rig up a pull set up.
1966 GMC Suburban 4x4
__________________
1964 Chevy Suburban 4x4 1966 GMC Suburban 4x4 |
|
|
|
12-04-2024, 02:35 PM
|
#2 |
|
Senior Member
Join Date: Feb 2004
Location: Williamsburg, Ohio
Posts: 1,798
|
Re: Front Leaf Top Rear Shackle Bushing Removal
Did you resolve this? If not, a ball joint installer remover probably will take it out using a correct socket punch pushing it to the inside. You may have to push out the steel bushing first.
__________________
1942 Chevy 1/2 ton Rod, 1959 GMC 1/2 ton Fleet Stepside, 1967 Chevy SWB K10, 1985 Corvette Coupe 4+3, 2015 Chevy Duramax reg cab 4WD W/T Last edited by dennislbrooks; 12-08-2024 at 05:55 AM. Reason: words |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
