|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-25-2025, 10:43 PM
|
#5 |
|
Registered User
Join Date: May 2011
Location: Anderson SC
Posts: 4,049
|
Re: Huge Ridgid/Columbian 6" Combo Vise Restoration
Started the lathe work last night but didn't get to finish, the motor that came with the lathe has always been weak and last night it finally bit the dust. I got the area of the shaft that goes through the dynamic jaw turned down, and started on the handle end but it died before I got it all the way cleaned up.
   The brass bushings and sleeves came in from McMaster so I can bore and sleeve the dynamic jaw's bore and the handle bore. I found the Athol 714 a couple weeks ago, it's pretty decent overall besides the ratcheting handle "repair". 
__________________
Project Goldilocks '66 C10 Short Fleet BBW Build '65 C10 Highly Detailed Stock Restoration Thread '78 Camaro Targa Roof Build '55 International Metal/Body/Paint Work '66 F100 Full Rotisserie Restoration '40 Packard 120 Convertible Coupe Restoration How To Restore and Detail an Original Gauge Cluster How To Detail Sand Body Panels, Edges, Corners, Etc |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode