Intake Torque Specs - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**76sierraclassic** · 09-02-2004, 02:42 PM

I'm going to change out my intake gaskets this weekend, but I don't have the torque specs for the intake manifold bolts. Can someone help me out here? I have a stock 76 GMC 350/350/4bbl-qjet.

Also, any tips or tricks you guys could throw my way for this would be appreciated. I've never tackled a job like this before, so I'm just going with the Haynes Manual and a little help from dad.

Thanks,
Mike

**swervin ervin** · 09-02-2004, 05:31 PM

Here you go.

**76sierraclassic** · 09-02-2004, 05:35 PM

Quote:

Originally Posted by swervin ervin

Here you go.

Thanks Mike!!!

Mike

Jonboy · 09-02-2004, 05:40 PM

also, use a bead of RTV silicone on the front and rear seal instead of the rubber end gaskets.

**76sierraclassic** · 09-02-2004, 05:47 PM

Quote:

Originally Posted by Jonboy

also, use a bead of RTV silicone on the front and rear seal instead of the rubber end gaskets.

Thanks for the tip. I was actually wondering about that. I saw that done on a show on TV the other day and wasn't sure if it was a good idea or not.

Mike

**swervin ervin** · 09-02-2004, 05:54 PM

http://www.73-87.com/7387garage/drivetrain/intake.htm

09-02-2004, 02:42 PM	#1
76sierraclassic Senior Member Join Date: Feb 2004 Location: White Hall, AR Posts: 316	Intake Torque Specs I'm going to change out my intake gaskets this weekend, but I don't have the torque specs for the intake manifold bolts. Can someone help me out here? I have a stock 76 GMC 350/350/4bbl-qjet. Also, any tips or tricks you guys could throw my way for this would be appreciated. I've never tackled a job like this before, so I'm just going with the Haynes Manual and a little help from dad. Thanks, Mike

09-02-2004, 05:31 PM	#2
swervin ervin You get what you pay for Join Date: Dec 1999 Location: Cherryville, NC Posts: 4,798	Here you go. Attached Images __________________ Mike 1985 Chevy C-10

09-02-2004, 05:40 PM	#4
Jonboy Slots go on anything! Join Date: May 2003 Location: Richardson, TX Posts: 5,957	also, use a bead of RTV silicone on the front and rear seal instead of the rubber end gaskets. __________________ 1974 Jimmy- 5.3/4L80e/NP241

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-02-2004, 05:54 PM	#6
swervin ervin You get what you pay for Join Date: Dec 1999 Location: Cherryville, NC Posts: 4,798	http://www.73-87.com/7387garage/drivetrain/intake.htm



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.