|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-02-2004, 08:39 PM
|
#1 |
|
Registered User
Join Date: Feb 2004
Location: Albany, NY
Posts: 522
|
quick question... can't remember
hey guys and gals... what size is a typical rear driveshaft u-joint for a 70 k10? i've bought about 5 of em but i can't remember to save my life!
__________________
RN U OVR |
|
|
|
09-02-2004, 08:43 PM
|
#2 |
|
user # 2756
 
Join Date: Jun 2001
Location: Chesapeake, Virginia
Posts: 4,612
|
Should be 1310.
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs 1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX 1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears 1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now..... 1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone. 1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed. 1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|
|
|
|
|
09-02-2004, 08:54 PM
|
#3 |
|
Registered User
Join Date: Feb 2004
Location: Albany, NY
Posts: 522
|
i'm dead sure yu're right. thanks. but now... a brand new question!!! a 14 bolt always has a 1350? i just bought a 14 bolt, but the guy i bought from is as cluless about the u-joint size as i was until yall helped me out.
__________________
RN U OVR |
|
|
|
|
09-02-2004, 09:28 PM
|
#4 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,598
|
About 90% of the 14 bolts have the 1350 u-joint. The later model 1 ton 14 bolts after 88 or 89 came with the 1410 yoke, depending on the GVW
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
