Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
01-09-2010, 11:56 PM | #26 |
Badass
Join Date: Jan 2009
Location: lox. fl
Posts: 4,586
|
Re: going racing friday night
alright i will.youll be seeing that new thread title "i blew up my motor now what?"
haha lets hope not
__________________
Think outside the box? -84c10 (1stcar)→My Build← -00 Saturn 5spd drop a gear and disappear! 1/4:13:90 |
01-10-2010, 12:04 AM | #27 | |
At the body shop.
Join Date: Aug 2009
Location: Land of fruits and nuts.
Posts: 5,260
|
Re: going racing friday night
Quote:
__________________
" That didnt make it any newer " " Dont antique the equipment " |
|
01-11-2010, 12:37 PM | #28 | |
Still plays with trucks
Join Date: Jul 2009
Location: Spokane, WA
Posts: 3,556
|
Re: going racing friday night
Quote:
It weighs too much being a 3/4-ton 4x4 and the SM465 makes it hard to shift quickly. In a much lighter C-10 truck it would be quite a bit quicker probably 14.30's or so. The same engine in my Chevelle ran 13.50's.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577 69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been 69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc 68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E 79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars |
|
01-11-2010, 04:44 PM | #29 |
Registered User
Join Date: Jul 2008
Location: Queen Creek, AZ
Posts: 538
|
Re: going racing friday night
|
01-11-2010, 06:28 PM | #31 | |
Registered User
Join Date: Aug 2009
Location: hillborough nc
Posts: 410
|
Re: going racing friday night
Quote:
__________________
77 chevy BIG 10 350/sm465/12bolt w 3.73 bout 240 horse power NO power steerin 79 chevy 1/2 ton 250/three on the tree/3.08s soon to get built 250/floor shift conversion/3.08s 81 mercedes 300d 25 MPG 77 chevy BIG DOOLEY 454/sm-465/14 bolt 4.10s "fully loaded" 73 plymouth duster 225 slant six/230 3 speed/8 1/4 trying to acheve 300 horse six http://www.cardomain.com/ride/3135091 '77 chevy trucks. built to stay tough. life is short build a hot rod |
|
01-11-2010, 06:38 PM | #32 |
Still plays with trucks
Join Date: Jul 2009
Location: Spokane, WA
Posts: 3,556
|
Re: going racing friday night
So can I but not anywhere near as quickly as an M21, T-5 or T-56 car trans.
With my Camaro I could shift with my foot to the floor on the throttle. Power shifts are brutal on the parts but the shifts can happen fast enough to not have to lift at all. Needless to say I broke quite a few transmissions.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577 69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been 69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc 68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E 79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars |
01-11-2010, 07:41 PM | #33 | |
Registered User
Join Date: Aug 2009
Location: hillborough nc
Posts: 410
|
Re: going racing friday night
Quote:
__________________
77 chevy BIG 10 350/sm465/12bolt w 3.73 bout 240 horse power NO power steerin 79 chevy 1/2 ton 250/three on the tree/3.08s soon to get built 250/floor shift conversion/3.08s 81 mercedes 300d 25 MPG 77 chevy BIG DOOLEY 454/sm-465/14 bolt 4.10s "fully loaded" 73 plymouth duster 225 slant six/230 3 speed/8 1/4 trying to acheve 300 horse six http://www.cardomain.com/ride/3135091 '77 chevy trucks. built to stay tough. life is short build a hot rod |
|
01-11-2010, 07:56 PM | #34 | |
Still plays with trucks
Join Date: Jul 2009
Location: Spokane, WA
Posts: 3,556
|
Re: going racing friday night
Quote:
The good thing about the gearing is that I can pull 3rd gear from a 10 mph roll and 4th from about 25.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577 69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been 69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc 68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E 79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars |
|
01-12-2010, 12:06 AM | #35 |
Registered User
Join Date: Dec 2009
Location: Milton, FL
Posts: 733
|
Re: going racing friday night
|
01-12-2010, 02:11 AM | #36 | |
fan of "Butters" Stotch
Join Date: Dec 2009
Location: St. Paul, MN
Posts: 267
|
Re: going racing friday night
Quote:
Some won't let you run with it. But if its just a "fun day", then they usually don't bother you about it
__________________
64 shortbox fleetside replacing rusty junk with more junk, and one day to become a real truck again |
|
01-12-2010, 02:14 AM | #37 |
Registered User
Join Date: Dec 2009
Location: Milton, FL
Posts: 733
|
Re: going racing friday night
|
01-12-2010, 12:51 PM | #38 | |
Still plays with trucks
Join Date: Jul 2009
Location: Spokane, WA
Posts: 3,556
|
Re: going racing friday night
Quote:
It is also extremely slippery. Blow a hose going down the track and it will get all over your tires and put you into a wall or worse into the other lane and possibly the other car.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577 69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been 69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc 68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E 79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars |
|
01-12-2010, 01:04 PM | #39 |
Registered User
Join Date: Oct 2007
Location: Turlock, Ca
Posts: 32
|
Re: going racing friday night
another tip for you, don't wait for green to launch, I found best rersults with leaving when the last yellow bulb lights, this will improve your reaction time.
|
01-12-2010, 02:11 PM | #40 | |
Still plays with trucks
Join Date: Jul 2009
Location: Spokane, WA
Posts: 3,556
|
Re: going racing friday night
Quote:
Every car and driver are different. It will take some experimentation and practice to figure it out for yourself. Good luck and have fun.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577 69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been 69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc 68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E 79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars |
|
01-13-2010, 05:52 PM | #41 |
Registered User
Join Date: Jul 2008
Location: Queen Creek, AZ
Posts: 538
|
Re: going racing friday night
what did the van run???
|
01-13-2010, 05:56 PM | #42 |
Still plays with trucks
Join Date: Jul 2009
Location: Spokane, WA
Posts: 3,556
|
Re: going racing friday night
It was in the high 18 second range. I don't remember the exact ET.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577 69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been 69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc 68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E 79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars |
01-13-2010, 06:05 PM | #44 |
Still plays with trucks
Join Date: Jul 2009
Location: Spokane, WA
Posts: 3,556
|
Re: going racing friday night
It could have used both.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was http://67-72chevytrucks.com/vboard/s...d.php?t=795577 69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been 69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc 68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E 79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars |
01-13-2010, 09:35 PM | #45 |
Registered User
Join Date: Apr 2009
Location: hurlock md
Posts: 82
|
Re: going racing friday night
a few years ago i ran a friends car at the local track in the super heavy class and the guy i was racing busted a fuel line and got on the track. cam II easy clean up but not to mention he got a 500 dollar fine for them having to close the track for 30 min for clean up. i dont know if all tracks do that but the one i go to does.
|
01-14-2010, 12:36 PM | #47 |
Registered User
Join Date: Jul 2008
Location: Queen Creek, AZ
Posts: 538
|
Re: going racing friday night
3r!c84
I want to see the 45mph lawnmower in action! lol |
01-14-2010, 02:08 PM | #48 |
Badass
Join Date: Jan 2009
Location: lox. fl
Posts: 4,586
|
Re: going racing friday night
i just sold it a few weeks ago ):
ive been looking for pics and cant find any of when it was done.but here was some b4 shots and my friends and i mudding heres it.but the burnout was when it only had a 5and3in pullys,,but when it was fast i put full go cart steering and a honda atc 200 motor in it
__________________
Think outside the box? -84c10 (1stcar)→My Build← -00 Saturn 5spd drop a gear and disappear! 1/4:13:90 Last edited by 3r!c84; 01-14-2010 at 02:09 PM. |
01-14-2010, 02:12 PM | #49 |
Badass
Join Date: Jan 2009
Location: lox. fl
Posts: 4,586
|
Re: going racing friday night
heres my orange one i made.it was getting painted and i just layed the wheels there.
and the rest are some of my others and friends getting down in mud
__________________
Think outside the box? -84c10 (1stcar)→My Build← -00 Saturn 5spd drop a gear and disappear! 1/4:13:90 |
01-14-2010, 05:59 PM | #50 |
Registered User
Join Date: Nov 2009
Location: Frederick, MD
Posts: 158
|
Re: going racing friday night
I have to say that I love this forum. If this short of guestion was asked on any other forums that I go on to. There would be nothing but flaming and bad mouthing going on. I love how everyone on here is helpful and is willing to chime in with knowledge.
Thanks guys.
__________________
05 Chevy 3500 Crew Cab Dually Sold 1984 Custom Deluxe K/30, 350 SBC with 4 Speed, 6" Lift, 35" Boggers, Headmen Headers, Custom Full 3" Dual Exhaust, Qualitex Buckets with Flip Center Console |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|