Cleaning a bare frame - Suggestions? - Page 2 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

JesseSimon · 08-30-2011, 09:27 PM

Hey guys, getting ready to start what will basically be a ground up build. Have a '66 LWB that I am swapping over to a '65 Short Stepside frame and bed. Just picked up the 65 stepper and it is COMPLETELY disassembled. So I have a bare frame. just rails and cross members. I want to clean it all up and put a good coat of paint on it before I start building on it. This is a budget build, anyone have an alternative cleaning method to sandblasting that they can suggest or should I bite the bullet and blast it?

08-30-2011, 09:27 PM	#1
JesseSimon Asks alot of questions Join Date: Feb 2009 Location: Rogers, Arkansas Posts: 231	Cleaning a bare frame - Suggestions? Hey guys, getting ready to start what will basically be a ground up build. Have a '66 LWB that I am swapping over to a '65 Short Stepside frame and bed. Just picked up the 65 stepper and it is COMPLETELY disassembled. So I have a bare frame. just rails and cross members. I want to clean it all up and put a good coat of paint on it before I start building on it. This is a budget build, anyone have an alternative cleaning method to sandblasting that they can suggest or should I bite the bullet and blast it? __________________ MY STABLE: '66 C10 LWB turning it into a shortbed stepside '77 LWB (my daily driver).....oh its a FORD ahhhhh! '07 MAZDA 3 (the wife's ride)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.