CA WTB Exhaust Pipe Hangers for '72 with BBC

[randy500]

Originally Posted by Race73ta

OK Randy, it looks like we're all in the dark again - so, according to the picture you posted earlier in the thread these are the tailpipe hangers ??

For a 72 big block with coil springs.

[Race73ta]

Originally Posted by randy500

72 big block hangars for leaf springs posted by an expert...I know him well and he knows his stuff, anything posted by Livrat or me can be relied upon.

I believe the above muffler and tailpipe hangars are symmetrical so can fit either side, I don’t have personal knowledge though,
It it’s not clear the above muffler hangar held a strap which went all the way around the muffler.

http://67-72chevytrucks.com/vboard/s...d.php?t=419491

I'm going with Livrat at this point because I know the ones I marked up on your pic are not what I have on my truck - at least the (1) original that is still there is like the Livrat pic

[randy500]

You need the stuff posted by Livrat for 1972 leaf springs, I also think those are for all years big block leaf springs.

[Race73ta]

Originally Posted by randy500

For a 72 big block with coil springs.

OK, these are for COIL SPRINGS - D. PASSMORE this is what you have !
Thanks Randy

[randy500]

I would have never posted mine if I knew u wanted leaf spring hangars....sorry I muddied it up. There are good references to what is needed in this thread though. Finally

[randy500]

I will add this, which I hope helps. I believe 4wd would be the same muffler and tailpipe hangars since all 4wd are leaf spring, if you post in the blazer section you might get some reponses. I’m assuming those 2 hangars are symmetrical and fit either side,

[Race73ta]

Originally Posted by randy500

I will add this, which I hope helps. I believe 4wd would be the same muffler and tailpipe hangars since all 4wd are leaf spring, if you post in the blazer section you might get some reponses. I’m assuming those 2 hangars are symmetrical and fit either side,

Thanks Randy and no problem on the slight bit of confusion - I know at least a handful of people now know more than they did last month on this subject. I will see what the 2 folks that think they have them have to say/post and go from there.

[Madkidd007]

Originally Posted by Race73ta

Hi Madd, Please check the link below - this shows what they look like

http://67-72chevytrucks.com/vboard/s...d.php?t=505660

Let me know if you have these.

That link doesn’t work, maybe something you have to have permission to view? Looking at this thread it may be wise to start a thread just on hangers for future references

[Race73ta]

Thanks, I see you got my PM with the picture so let me know what you find.

[uncle]

11111

[uncle]

22222

[uncle]

I’m sure these front tail pipe hangers are not complete and the strap has been added.

[uncle]

4444

[uncle]

5555

[uncle]

66666

[Race73ta]

Thanks Uncle - I need the ones Behind the rear end - these look like the ones before the axle. Thanks !

[uncle]

I just realized that a truck that I have sold also has these brackets on it. So here’s a picture of what I believe is correct. As I just said this truck no longer belongs to me, I just haven’t delivered it yet.

[Race73ta]

OK, now I see all the pictures, Thanks !

[uncle]

One more.

[uncle]

Last one.