57 Panel "FAKMLC" build

[MiraclePieCo]

Originally Posted by FAKKY

Took her to home depot for her first "load"
Went well.

Got to quieten the enterior in the back and windows a bit more.
Longer term might look at slightly higher rate leafs in rear and raise her 1-2".

NICE!

BTW, are those Super Slide springs you're using? Someone on the forum was asking how everyone liked them.

[6DoF]

no garage candy here, nice!

[FAKKY]

Sorry had a few things going on - getting the house ready to sell.

Originally Posted by BBPanel

What are you thinking about doing re soundproofing? I will need to do the same on my '56 Panel. The windows? Confused.
I asked about a similar issue here but didn't get much back: https://www.trifive.com/threads/pane.../#post-2458660

For me most of my noise is coming in the doors/windows. Rattles and air. So need to get the new windows and tracking in place as well as seals and a few pieces of insulation inside the door skin to give it a bit of weight for vibrations to dull out.

Originally Posted by MiraclePieCo

NICE!

BTW, are those Super Slide springs you're using? Someone on the forum was asking how everyone liked them.

Sorry miracle didnt see your question here .... not sure what super slide springs are ?

Originally Posted by 6DoF

no garage candy here, nice!

[FAKKY]

What did everyone do to treat the rust on side of door skin.



Im thinking of using a long adapter and wire wheel ..... hit the rest with red scrub pad .... then wipe it down with corrseal or spray with rust convertor ?

Better way without cutting an access in bottom of doorskin (might eventually have to do that? )

[6DoF]

my plan was a scotch bright by hand, blow it out, and spray with with RustPrep to seal.