What did you and your square body do today?

[piecesparts]

We updated the tranny in preps for the HRPT.

[OleBlue79]

I sat in a traffic jam for 5 hours because part of the Interstate was closed while going to pick up a 700R4 to replace my TH400.

[asphaltburner]

Yo! FRANKENTRUCK got it's HEI finely tuned a bit more,...lighter weights and moderately heavy springs proved to be the proper ignition combo. Today I advanced my initial timing. After test driving this afternoon, I think I'll back that off about four degrees, retest, and then reattach my vacuum advance and tune it (with it's Allen wrench) slowly to proper "mid-throttle" response.
Todd.

[Goldfinger]

took pictures of my c10 to post later.

[joe1982]

i found square body heaven!!!!! salvage yard about 2 miles from myhouse, thee were litraly 4 rows, about 1cty block long full of squarebodie, 24 years of living here, i always thoght it was part of the marine corps base, never realized it was a truck yard.

[cr8zchevyguy]

painted my 82 semi gloss black, going for that hot rod look!

[BGRAFX]

Holy SquareBody Heaven!!!! I'm jealous.

Cr8zychevy guy, where are the pix and what paint did you use?

[nlped]

Took the Blazer and delivered the extra 12 bolt rearend to my "gear guy" to have the Auburn Posi, 3.42 r&p, all new bearings & seals installed, along with the machined axles to accomodate the McGaughy 13" rear Big Brake kit . It will be replacing the one under it now, so I won't be down for too long.

[staggerd86c-10]

i wish i had a squarebody heaven around here, i havent had luck to find even one in a junkyard anywhere around here.

[cr8zchevyguy]

BGRAFX, i'll try to post some pics a little later. i used rustoleum semi gloss black, thined it out with mineral sprits, and used a paint gun.... came out good.

[shloopter]

Removed a leaf spring on each side to level this thing out. I think I'm going one more then put some helper bags on it. Also installed a roll pan. Still need to do the body work but it looks a lot better.