CA 4x4 sway bar changeover

[KrazyRay]

I have a pair from a 69. $55 shipped.
Thanks,
Ray

[67gmcstepside]

Ray, i received the sway bar setup but the spring packs that came with it are 2 different sizes of which neither fits my existing setup. I have a 72 blazer 1/2 axle in front. Are these for the 3/4 ton setups only?

[KrazyRay]

They should all be the same. The plate on the passenger side is bigger to allow for the pumkin. Center to center of the holes should be 3 5/8" on three of them and 4 3/8" on one hole (the one up against the pumkin. Here's some pics of a 1/2 ton that I just pulled yesterday:

[67gmcstepside]

Thanks Ray, once it stops rainning i will try another trial fit.

[2003 silverado]

Ray iam in search of the brackets in post #94 As I have the plates mounted and the bar but my blazer never had the brackets. In a previouse post someone asked about a lift on there trk ,They sell disconnect links for the sway bar and it raises the sway bay two inches from the axel>Hope that helped him Let me know what you have ? Thanks Dave 19382

[KrazyRay]

Dave, Those are the tough pieces to get for the setup. You have to sacrafice a 4x4 square body frame to get them. Also, the front crossmember is a little different on a 72 so you might have to do some fab work to make it happen. I have a 77 crossmember with those brackets, but there is some welds that I had to cut that will need to be cleaned up...very useable. $65 shipped for the crossmember and brackets.
Thanks,
Ray