|
07-08-2004, 01:06 PM
|
#1 |
|
Registered User
Join Date: Jun 2002
Location: Fort Worth, TX
Posts: 920
|
ignition
I've just switched my 6 cylinder to a petronix ignitor system to keep from changing points. I've also added a flamethrower coil. Problem is I'm going thru distributor caps and rotors now. Is there a better brand someone could recommend. I've been using stock parts up until now. I've heard good things about a line classic products has. Any help?
|
|
|
|
07-08-2004, 01:20 PM
|
#2 |
|
blood type; Retumbo
Join Date: Jan 2004
Location: next to my reloading bench
Posts: 10,269
|
one word (wel actually 3)
HEI reason, more distance between cyl. towers in cap so you dont end up with burned contacts. not to mention the reliability & simplicity.
__________________
Man rule #77...if you own a 67 stepside with a caddy 472 you will never be in danger of loosing you man card |
|
|
|
|
07-08-2004, 06:41 PM
|
#3 |
|
Fabricate till you "puke"
Join Date: Jun 2002
Location: Ill
Posts: 9,402
|
Dunno, I am running a pertronix conversion in an old points dist)cast iron, from a 64 chev)+ coil & a good recurve. I like it better than the HEI that i pulled out! I would look for a Bluestreak, Accel, or any others that have brass contacts in the cap. i have heard the stuff about spacing with the bigger caps......but IMO ,its BS. I can twist my 383 as tight as I want with the small cap, & no missfires
 best of luck,crazyL 
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears.... |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
