SBC Temp Sender for Small holes - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Woody1 · 09-24-2004, 11:28 PM

Ok,
I promiced that I would post this for another member...Can't remember his ID and it was while I was at work today....and I forgot my PW so I had to register as Woody1 from home... so this has taken alot of my lawn mowing time this evening.

Here's the info I found at home.
Niehoff Ignition Co. p/n GA56

This was posted a few months ago by someone else and they said that it fit and was calibrated for the guage in the dash.

Woody1 aka Woody (from work)

Time to mow

Longhorn Man · 09-24-2004, 11:29 PM

Is this the one that will fit in a later Votec head, and (as you stated) calibrated for the stock truck guage?

09-24-2004, 11:28 PM	#1
Woody1 Registered User Join Date: Sep 2004 Posts: 3	SBC Temp Sender for Small holes Ok, I promiced that I would post this for another member...Can't remember his ID and it was while I was at work today....and I forgot my PW so I had to register as Woody1 from home... so this has taken alot of my lawn mowing time this evening. Here's the info I found at home. Niehoff Ignition Co. p/n GA56 This was posted a few months ago by someone else and they said that it fit and was calibrated for the guage in the dash. Woody1 aka Woody (from work) Time to mow

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-24-2004, 11:29 PM	#2
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,693	Is this the one that will fit in a later Votec head, and (as you stated) calibrated for the stock truck guage?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.