Seat belt roller tension - The 1947 - Present Chevrolet & GMC Truck Message Board Network

duke10 · 11-24-2004, 09:45 PM

Is there some trick to getting the seat belts to spring back down after you unbuckle? I am having a tough time keeping the spring loaded and getting the pin through. Someone tell me there is a trick or an easier way to get this done. Thanks

duke10 · 11-26-2004, 01:07 PM

ttt

Scottri · 11-26-2004, 04:39 PM

I pulled a set out of a truck in the boneyard once and took them apart and was able to re-tension them but I don't remember how but it can be done.

Scott

duke10 · 11-26-2004, 11:56 PM

thanks scott

11-24-2004, 09:45 PM	#1
duke10 Active Member Join Date: Aug 2003 Location: san diego Posts: 833	Seat belt roller tension Is there some trick to getting the seat belts to spring back down after you unbuckle? I am having a tough time keeping the spring loaded and getting the pin through. Someone tell me there is a trick or an easier way to get this done. Thanks

11-26-2004, 04:39 PM	#3
Scottri Registered User Join Date: Jul 2000 Location: Beaverton Oregon USA Posts: 338	I pulled a set out of a truck in the boneyard once and took them apart and was able to re-tension them but I don't remember how but it can be done. Scott __________________ 1969 GMC 3/4 Ton Long Bed Fleetside 350, 4 speed manual, P/S, P/B, Edelbrock 1406 Carb Beaverton / Portland Oregon

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-26-2004, 01:07 PM	#2
duke10 Active Member Join Date: Aug 2003 Location: san diego Posts: 833	ttt

11-26-2004, 11:56 PM	#4
duke10 Active Member Join Date: Aug 2003 Location: san diego Posts: 833	thanks scott



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.