![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Member since 2000
Join Date: Dec 2000
Location: Mountain View Ca / Mexico
Posts: 7,879
|
![]()
i remeber there was a post that someone made there own line from the tranny to the cooler. Who made them? Where did you get the materials? the tools? Photo on how you ran the setup? What steps did you take?
Any help would be great guys. |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Nov 2000
Location: Huntsville Ontario Canada
Posts: 4,052
|
Go to your local part's store and get a roll of stainless line a fare tool kit tubing bender is nice to have but with stainless it does not kink very easy and some line nut's there are instructions in the flare tool kit. It pretty easy.
Later Mario
__________________
1968 Suburban numbers matching all original truck now equipped with 6.0/4L80 on Accuair http://67-72chevytrucks.com/vboard/s...d.php?t=625017 1967 C/20 6.0/4L80 Roofing Truck 1990 V2500 Suburban "Plow Truck" 2005 TAHOE DD |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: May 2000
Location: Frankfort, Kentucky, USA
Posts: 2,163
|
I'm running mine in braded. Haven't started it yet. Darn job/house/part time school sucks.
__________________
'69 CST Short fleetside Lowered, 400 small block, 700R4, 4 wheel disc brakes, front sway bar & rear camaro sway bar (in progress) '87 V10 4x4 Short Fleetside Quad Suspension and Dual Tanks |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|