Alum bushings for rear trak bar - The 1947 - Present Chevrolet & GMC Truck Message Board Network

kelsfine69 · 03-31-2005, 07:42 PM

1967-72 GMC ..Anyone ever remove the rubber bushings and install aluminum ones, or is it better to go to poly from energy suspensions

Low69CST · 03-31-2005, 08:29 PM

You could make one with a lathe, but i doubt you'd notice the difference between that and poly. Poly is what i'm using by the way.

neonlarry · 03-31-2005, 09:19 PM

Save yourself the trouble, have a look at these (about half way down the page).
http://www.stockcarproducts.com/trkarm.htm

03-31-2005, 07:42 PM	#1
kelsfine69 18 Till I Die Join Date: Mar 2005 Location: Alberta, Canada Posts: 1,522	Alum bushings for rear trak bar 1967-72 GMC ..Anyone ever remove the rubber bushings and install aluminum ones, or is it better to go to poly from energy suspensions

03-31-2005, 08:29 PM	#2
Low69CST Registered User Join Date: May 2000 Location: Frankfort, Kentucky, USA Posts: 2,163	You could make one with a lathe, but i doubt you'd notice the difference between that and poly. Poly is what i'm using by the way. __________________ '69 CST Short fleetside Lowered, 400 small block, 700R4, 4 wheel disc brakes, front sway bar & rear camaro sway bar (in progress) '87 V10 4x4 Short Fleetside Quad Suspension and Dual Tanks

03-31-2005, 09:19 PM	#3
neonlarry Registered User Join Date: Feb 2002 Location: Vacaville, CA Posts: 2,745	Save yourself the trouble, have a look at these (about half way down the page). http://www.stockcarproducts.com/trkarm.htm __________________ 70 C/10 Light Red 350/TH350, HEI, Duals w/40 series Flows, 91 seat, LED taillights 99 Pontiac S/C GTP, SLP Ram Air hood, GMPP Konis & springs 95 Neon ACR, MP PCM, AFX UDP, 3.0 CAI

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.