![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Dec 2004
Location: El Mirage, Az.
Posts: 19
|
Another Sway Bar Question
I was strolling through the wrecking yard and came across a 68 chevy with the factory sway bar on it. I had the rivits cut off the brackets and took everything home. Here is my question. The 4 bushings are marked as the stock diameter 1 1/16" but they seem to have a small gap once installed on the bar. They seem to be in pretty good shape, but I will replace them anyway. Do the bushings have to be completely tight around the sway bar or are they supposed to have a gap to allow the bar to pivot slightly? Thanks!!
|
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Dec 2002
Location: Tampa
Posts: 1,191
|
Tight. Being loose just allows that much more body roll before the sway bar starts doing its job.
__________________
'68 Short Step LS1/T56, Hydratech, Fatman Fabrications Stage III, Baer, Hot Rods to Hell, US Body, S&W, etc |
![]() |
![]() |
![]() |
#3 |
Mike
Join Date: Jan 2003
Location: west chester pa
Posts: 2,474
|
Your new ones should be tight.It is hard to tell how old the used ones are.The rubber wears and shrinks with age.
__________________
70'c/10, 71 suburban4x4 402bb, 72suburban 4/6 drop, 72k/5 4x4 blazer 4" lift 35 tires |
![]() |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|