Need: Bushings for NP205 shift handle - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**Daubs** · 04-29-2005, 03:23 PM

1972 K20 with four speed manual and the 205 t-case. The t-case shifter rattles above 50 MPH (really annoying and loud). I tried putting some grease in, but just pours out the side.

Buddy said there may be a bushing for the handle? If not, any recommendations?

Thanks, D.

poff · 05-02-2005, 12:00 PM

I could not find replacement stock bushing anywhere. I had my buddy make me a new metal sleeve on the lathe and got off-the-shelf bushings from McMaster Carr. If you can find a later model adapter they use a different bolt that is still available.

Brewski* · 05-02-2005, 04:23 PM

I tried everything including "Factory" plastic bushings and they were still sloppy and my bolt continued to come loose. Finally I Went to ACE hardware with the shifter and the bolt. I found 2 bronze bushings which fit into the shifter hole and allowed the bolt to fit through perfect or maybe a little tightI may have sanded the inside slightly. When they when pushed together from both sides of the shifter piviot hole were a little long so I ground one of them down. The shifter is rock solid and has not come loose or rattled since 2002.

04-29-2005, 03:23 PM	#1
Daubs Registered User Join Date: Jan 2005 Location: Eastern Nebraska Posts: 613	Need: Bushings for NP205 shift handle 1972 K20 with four speed manual and the 205 t-case. The t-case shifter rattles above 50 MPH (really annoying and loud). I tried putting some grease in, but just pours out the side. Buddy said there may be a bushing for the handle? If not, any recommendations? Thanks, D. __________________ '72 Chevy K-20 Crate 350, SM465, 4.10's

05-02-2005, 12:00 PM	#2
poff Registered User Join Date: Dec 1999 Location: san diego, ca Posts: 546	I could not find replacement stock bushing anywhere. I had my buddy make me a new metal sleeve on the lathe and got off-the-shelf bushings from McMaster Carr. If you can find a later model adapter they use a different bolt that is still available. __________________ '70 K-20 San Diego, CA Last edited by poff; 05-02-2005 at 04:47 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-02-2005, 04:23 PM	#3
Brewski* Registered User Join Date: Aug 2001 Location: Rocky Mount, MO Posts: 1,293	I tried everything including "Factory" plastic bushings and they were still sloppy and my bolt continued to come loose. Finally I Went to ACE hardware with the shifter and the bolt. I found 2 bronze bushings which fit into the shifter hole and allowed the bolt to fit through perfect or maybe a little tightI may have sanded the inside slightly. When they when pushed together from both sides of the shifter piviot hole were a little long so I ground one of them down. The shifter is rock solid and has not come loose or rattled since 2002.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.