which truck 5 speed is a bolt in? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Olden Days · 05-11-2005, 10:48 AM

I thought I saw on here where some people said a certain year truck had a manual 5 speed that was pretty much a bolt in. I would like to look into doing this swap on one of my projects if feasable. thanks...

1low1967 · 05-11-2005, 11:48 AM

I'm going to be running a nv3500 out of a 2wd 89 gmc. It bolted up to my 350 block, I just have to figure out the master and slave cylinder part but thats a few months off. Deffently have to move the trans mount

ryanroo · 05-11-2005, 02:43 PM

i replaced my sm465 with a NV4500 not a 100% bolt in but it was close. there is a page in the FAQ section that has all the details
Ryan

Olden Days · 05-11-2005, 10:11 PM

thanks for the replys. I cant seem to get anything to come up in the FAQ when I search for it. Would you happen to have a link to it?
edit: Nevermind I did find it. Good write up. I just want to be clear, you did not have to convert to a hydraulic clutch did you?

ryanroo · 05-12-2005, 01:45 AM

no sir, i used a Advance adapters bell housing that allowed me to retain the factory linkage
ryan

05-11-2005, 10:48 AM	#1
Olden Days Living In The Past Join Date: Nov 2003 Location: Rockies Posts: 709	which truck 5 speed is a bolt in? I thought I saw on here where some people said a certain year truck had a manual 5 speed that was pretty much a bolt in. I would like to look into doing this swap on one of my projects if feasable. thanks...

05-11-2005, 02:43 PM	#3
ryanroo Senior Member Join Date: Apr 2004 Location: sw colorado Posts: 2,720	i replaced my sm465 with a NV4500 not a 100% bolt in but it was close. there is a page in the FAQ section that has all the details Ryan __________________ 72 K20 12v build 72 K20 "parts truck" A place for your diesel swap questions

05-11-2005, 10:11 PM	#4
Olden Days Living In The Past Join Date: Nov 2003 Location: Rockies Posts: 709	thanks for the replys. I cant seem to get anything to come up in the FAQ when I search for it. Would you happen to have a link to it? edit: Nevermind I did find it. Good write up. I just want to be clear, you did not have to convert to a hydraulic clutch did you? Last edited by Olden Days; 05-11-2005 at 10:18 PM.

05-12-2005, 01:45 AM	#5
ryanroo Senior Member Join Date: Apr 2004 Location: sw colorado Posts: 2,720	no sir, i used a Advance adapters bell housing that allowed me to retain the factory linkage ryan __________________ 72 K20 12v build 72 K20 "parts truck" A place for your diesel swap questions

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-11-2005, 11:48 AM	#2
1low1967 Registered User Join Date: May 2005 Location: Mohnton Posts: 87	I'm going to be running a nv3500 out of a 2wd 89 gmc. It bolted up to my 350 block, I just have to figure out the master and slave cylinder part but thats a few months off. Deffently have to move the trans mount



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.