|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
07-03-2005, 01:06 PM
|
#1 |
|
Registered User
Join Date: May 2004
Location: Lakeville, MA
Posts: 154
|
Removing small rust spots
What grit sandpaper should I use to remove small rust spots? I have a few forming inside of my door and i would like to take care of them now. I know I need to get some black primer to put on it once i sand it down to bare metal, right?
__________________
1967 Chevy C10 Stepside - Vortech supercharged - Currently for sale |
|
|
|
07-03-2005, 11:24 PM
|
#2 |
|
Designated A-hole!
Join Date: Mar 2003
Location: South Mississippi
Posts: 36,450
|
Might be better to post this in Paint and Body, but here's a ttt for ya.
__________________
"If it ain't broke, fix it 'til it is!" Being stupid ain't illegal.  We're Still Debt Free Except for the House!!! www.daveramsey.com 70 GMC SWB Stepside project "Green Booger" soon to be 6.0l/4l80e 93 S-10 "Poppaw's Truck" |
|
|
|
|
07-04-2005, 12:54 AM
|
#3 |
|
Registered User
Join Date: Nov 2004
Location: "Under Montana skies."
Posts: 1,836
|
Anthing from 60 to a little over 100. I would take a wire tooth brush and just knock of the lose scale, clean it well, let it thoroughly dry, wet with zinc phosphate to convert the rust, lightly rinse with water, let it dry completely, and then coat it with rust convertor or sealer.
I've recently found that Eastwood's Rust Encapsulator works well to seal prepped surface rust.
__________________
'71 GMC K20 Suburban, '71 GMC K10 Suburban, '72 Chevy C10 CST Suburban, '72 Chevy K20 clunker pickup. Last edited by 4x4Poet; 07-04-2005 at 12:57 AM. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
