Gauging interest on parts.... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

fade94 · 08-07-2005, 03:11 PM

Raining here right now, so no pics yet.
69 Chevy C10. Rams horn ex. manifolds. Driver side has sheet metal over it and the tube that goes into the air cleaner, I have the air cleaner too.
Rad support. No rusted thru spots found yet, but still trying to get enough parts off to see pass side.
Truck has aux fuel tanks. One each side of bed as well as cab tank. Cab is in very good condition considering others I have seen. Both rockers need to be replaced. But, floor looks to be in very good condition on dr side. Pass side has rust above rocker. Still trying to fight off the red wasps to get more parts pulled. Will check rust situation on pass side inner fender. I am using the driver side on my truck. Will get pics if someone interested in buying.

bagged91 · 08-07-2005, 04:20 PM

$$$ with shipping to NJ 08071 on exhaust manifolds w/tube & aircleaner. Is it a 2bbl or 4bbl?

Thanks. Joe

qksilver · 08-07-2005, 04:39 PM

i might be interested in the aux tanks and fuel selector, depending on price and shipping. Already have enough in cab tanks.
Pm me please,
Thanks,
Steve

Americanrider · 08-07-2005, 09:22 PM

Redneck cure for wasp nests is CARB Cleaner

kills 'em dead & the nest too....

Just remember not to smoke

around the truck for a while!

**w314speed** · 08-07-2005, 09:24 PM

I'm second in line for the auxilary fuel tanks with selector and filldoors from each bedside. $$$$ with shipping to 30127. Thanks, Dan

fade94 · 08-08-2005, 08:01 AM

Not the best, but the motor is still in the truck so it's pretty tight.

fade94 · 08-08-2005, 08:03 AM

Guys interested in fuel tanks...
These tanks are filled inside the rear wheel opening. I think they are fiberglass unless there is a cover on them. No filler doors on truck. The switch/lever, is next to the end of the driver seat right inside the door.

fade94 · 08-08-2005, 08:40 AM

Quote:

Originally Posted by bagged91

$$$ with shipping to NJ 08071 on exhaust manifolds w/tube & aircleaner. Is it a 2bbl or 4bbl?

Thanks. Joe

4 bbl. Still need to pull manifolds off and make sure they are ok. "Should" be pulling the motor this week.

qksilver · 08-08-2005, 10:01 PM

yep, i have them on my Longhorn and a swb.
I am located in NC 28387
Thanks,
Steve

fade94 · 08-08-2005, 10:10 PM

Going to be a few days until I can get shipping costs. I want to get the tanks off and make sure they are ok measure and weigh them.

Americanrider · 08-09-2005, 11:33 AM

Interested in the rod from brake pedal to booster but please send measurement first.
Ship to 98378 by whatever is cheapest (US Mail most likely).
Thanks!

zachary2001 · 08-09-2005, 11:39 AM

Fade,

If These Guys Fall Through On The Tanks I Would Be Interested In Them I Work In Mckinney So I Drive Through Melissa 2 Times A Day Going Ot And From Work.

bagged91 · 08-09-2005, 03:05 PM

I just noticed that the truck is Med Olive Green. Does it have a dk. olive interior? If so, I would be interested in the arm rests if they aren't too bad, possibly the doorpanels depending on condition and the green cover for the rear view mirror in addition to the exhaust manifolds...

If you want to email me pics of those items, you can send them to:

joeking1104@msn.com

Thanks again!
Joe

fade94 · 08-09-2005, 03:35 PM

Quote:

Originally Posted by bagged91

I just noticed that the truck is Med Olive Green. Does it have a dk. olive interior? If so, I would be interested in the arm rests if they aren't too bad, possibly the doorpanels depending on condition and the green cover for the rear view mirror in addition to the exhaust manifolds...

If you want to email me pics of those items, you can send them to:

joeking1104@msn.com

Thanks again!
Joe

Believe it or not, the door panels and kick panels are.....TUCK AND ROLLED

It has the arm rests, but I can't remember if they are black or green. The tuck is black. Will take pics when I get home, weather permitting.

bagged91 · 08-09-2005, 03:43 PM

Darn! Well, I could still use the mirror cover...

Did you check your A/C question post out?

fade94 · 08-09-2005, 03:47 PM

Quote:

Originally Posted by bagged91

Darn! Well, I could still use the mirror cover...

Did you check your A/C question post out?

Not yet. I won't have the inside unit until this evening. The green truck was GIVEN to my son. The guy that had it gave it to him in payment for pulling a motor and trans out of a car for him. I claimed the A/C stuff under hood since I am getting the inside unit from a board member. And, since he will be using my tools and lift and driving my truck until his is done, it's the least he can do...

fade94 · 08-09-2005, 03:49 PM

Quote:

Originally Posted by bagged91

Darn! Well, I could still use the mirror cover...

Did you check your A/C question post out?

PM sent to you bagged91

08-07-2005, 03:11 PM	#1
fade94 Registered User Join Date: Mar 2005 Location: Melissa, TX Posts: 799	Gauging interest on parts.... Raining here right now, so no pics yet. 69 Chevy C10. Rams horn ex. manifolds. Driver side has sheet metal over it and the tube that goes into the air cleaner, I have the air cleaner too. Rad support. No rusted thru spots found yet, but still trying to get enough parts off to see pass side. Truck has aux fuel tanks. One each side of bed as well as cab tank. Cab is in very good condition considering others I have seen. Both rockers need to be replaced. But, floor looks to be in very good condition on dr side. Pass side has rust above rocker. Still trying to fight off the red wasps to get more parts pulled. Will check rust situation on pass side inner fender. I am using the driver side on my truck. Will get pics if someone interested in buying. __________________ 68 short bed driver (71 clip on it now, swapping to 68 when weather cooperates) 67 short step project (will get SWB from the 68) 67 Camaro, #'s matching (my wife's) 03 Dodge Ram 2500 4x4 diesel 5 speed 4.10 rear

08-07-2005, 04:20 PM	#2
bagged91 Out draggin' Join Date: Jan 2004 Location: Pitman,NJ Posts: 1,574	$$$ with shipping to NJ 08071 on exhaust manifolds w/tube & aircleaner. Is it a 2bbl or 4bbl? Thanks. Joe __________________ 91 GMC Xcab LB-Bags/bd/caddy clip SOLD 72 C10 Cheyenne Super LWB SOLD 92 GMC K1500 Burb 72 C10 Burb (ex. Cheesewagon)SOLD 72 C20 Burb parts truck 71 C10 Burb "project"

08-07-2005, 09:22 PM	#4
Americanrider Registered User Join Date: Dec 2004 Location: NW, WA. Posts: 1,421	Redneck cure for wasp nests is CARB Cleaner kills 'em dead & the nest too.... Just remember not to smoke around the truck for a while! Last edited by Americanrider; 08-07-2005 at 09:23 PM.

08-08-2005, 08:01 AM	#6
fade94 Registered User Join Date: Mar 2005 Location: Melissa, TX Posts: 799	Pics Not the best, but the motor is still in the truck so it's pretty tight. Attached Images __________________ 68 short bed driver (71 clip on it now, swapping to 68 when weather cooperates) 67 short step project (will get SWB from the 68) 67 Camaro, #'s matching (my wife's) 03 Dodge Ram 2500 4x4 diesel 5 speed 4.10 rear

08-08-2005, 08:03 AM	#7
fade94 Registered User Join Date: Mar 2005 Location: Melissa, TX Posts: 799	Guys interested in fuel tanks... These tanks are filled inside the rear wheel opening. I think they are fiberglass unless there is a cover on them. No filler doors on truck. The switch/lever, is next to the end of the driver seat right inside the door. __________________ 68 short bed driver (71 clip on it now, swapping to 68 when weather cooperates) 67 short step project (will get SWB from the 68) 67 Camaro, #'s matching (my wife's) 03 Dodge Ram 2500 4x4 diesel 5 speed 4.10 rear

08-07-2005, 04:39 PM	#3
qksilver Senior Member Join Date: Dec 2004 Location: Southern Pines NC Posts: 3,853	i might be interested in the aux tanks and fuel selector, depending on price and shipping. Already have enough in cab tanks. Pm me please, Thanks, Steve

08-07-2005, 09:24 PM	#5
w314speed Senior Member Join Date: Jun 2005 Location: atlanta Posts: 2,317	I'm second in line for the auxilary fuel tanks with selector and filldoors from each bedside. $$$$ with shipping to 30127. Thanks, Dan

08-08-2005, 10:01 PM	#9
qksilver Senior Member Join Date: Dec 2004 Location: Southern Pines NC Posts: 3,853	yep, i have them on my Longhorn and a swb. I am located in NC 28387 Thanks, Steve

08-08-2005, 10:10 PM	#10
fade94 Registered User Join Date: Mar 2005 Location: Melissa, TX Posts: 799	Going to be a few days until I can get shipping costs. I want to get the tanks off and make sure they are ok measure and weigh them. __________________ 68 short bed driver (71 clip on it now, swapping to 68 when weather cooperates) 67 short step project (will get SWB from the 68) 67 Camaro, #'s matching (my wife's) 03 Dodge Ram 2500 4x4 diesel 5 speed 4.10 rear

08-09-2005, 11:33 AM	#11
Americanrider Registered User Join Date: Dec 2004 Location: NW, WA. Posts: 1,421	Interested in the rod from brake pedal to booster but please send measurement first. Ship to 98378 by whatever is cheapest (US Mail most likely). Thanks!

08-09-2005, 11:39 AM	#12
zachary2001 Registered User Join Date: Aug 2005 Location: Celeste Texas Posts: 67	Saddle Tanks Fade, If These Guys Fall Through On The Tanks I Would Be Interested In Them I Work In Mckinney So I Drive Through Melissa 2 Times A Day Going Ot And From Work.

08-09-2005, 03:05 PM	#13
bagged91 Out draggin' Join Date: Jan 2004 Location: Pitman,NJ Posts: 1,574	I just noticed that the truck is Med Olive Green. Does it have a dk. olive interior? If so, I would be interested in the arm rests if they aren't too bad, possibly the doorpanels depending on condition and the green cover for the rear view mirror in addition to the exhaust manifolds... If you want to email me pics of those items, you can send them to: joeking1104@msn.com Thanks again! Joe __________________ 91 GMC Xcab LB-Bags/bd/caddy clip SOLD 72 C10 Cheyenne Super LWB SOLD 92 GMC K1500 Burb 72 C10 Burb (ex. Cheesewagon)SOLD 72 C20 Burb parts truck 71 C10 Burb "project"

08-09-2005, 03:43 PM	#15
bagged91 Out draggin' Join Date: Jan 2004 Location: Pitman,NJ Posts: 1,574	Darn! Well, I could still use the mirror cover... Did you check your A/C question post out? __________________ 91 GMC Xcab LB-Bags/bd/caddy clip SOLD 72 C10 Cheyenne Super LWB SOLD 92 GMC K1500 Burb 72 C10 Burb (ex. Cheesewagon)SOLD 72 C20 Burb parts truck 71 C10 Burb "project"

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.