|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-09-2006, 05:20 PM
|
#1 |
|
Registered User
Join Date: Mar 2005
Location: Salem, New Jersey
Posts: 4
|
rear suspension control arms
I'm working on a 69 C20 and have a 67 C10 for parts. Will the control arms off the 67 fit the 69? All the measurements are the same. The only difference I see is the C20 arms have a strap welded to the bottom,
|
|
|
|
01-09-2006, 06:22 PM
|
#2 |
|
Registered User
Join Date: Feb 2002
Location: Vacaville, CA
Posts: 2,746
|
Re: rear suspension control arms
They will fit fine, with the added advantage of the extra bracing.
__________________
 70 C/10 Light Red 350/TH350, HEI, Duals w/40 series Flows, 91 seat, LED taillights 99 Pontiac S/C GTP, SLP Ram Air hood, GMPP Konis & springs 95 Neon ACR, MP PCM, AFX UDP, 3.0 CAI |
|
|
|
|
01-09-2006, 07:37 PM
|
#3 |
|
Registered User
Join Date: Nov 2003
Location: Alexandria, VA
Posts: 1,534
|
Re: rear suspension control arms
Fab a new reinforcement for the C-10 trailing arms from mild steel and weld it on.
__________________
'72 GMC SWB C1500 Custom, frame-off in progress. 383 SBC, 9:1CR, Comp Cams XE262H, Scat internal balanced crank, Eagle SIR 6" rods, Keith Black dish pistons, Dart Iron Eagle 72/180 heads, Weiand Stealth intake, Stewart stage I water pump, Holley 4bbl vac sec, TH350 with B&M Shift Improver Kit. 12 bolt positraction.   
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
