|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-30-2006, 10:14 AM
|
#1 |
|
Senior Member
Join Date: Jul 2003
Location: Indianapolis, IN
Posts: 1,277
|
Disc brake swap hardware
I have all the parts required to install disk brakes on a 1/2 ton. These were recently removed from an 84 or 86 1/2 ton. You get.
Upper and Lower control arms - need lower ball joints Spindles, calipers, rotors, brake hoses - 1" thick rotors Centerlink with pitman and idler arms - need two tie rod ends Proportioning valve Master cylinder - alum body, plastic reservoir Four new rubber bushings for lower control arms Asking $60 or trade for 73-87 parts. These are heavy, so no shipping. |
|
|
|
03-30-2006, 03:52 PM
|
#2 |
|
Registered User
 
Join Date: Feb 2004
Location: Idaho
Posts: 4,033
|
Re: Disc brake swap hardware
Will these bolt up directly to the 67-72 chasis?
__________________
"Remember, They can Kill You, but they can't eat You, That's against the law!!!!!!!!!" |
|
|
|
|
03-30-2006, 10:16 PM
|
#3 |
|
Senior Member
Join Date: Dec 2004
Location: Southern Pines NC
Posts: 3,853
|
Re: Disc brake swap hardware
Yes they will, plus the replacement parts are cheaper and with the rubber bushings it will ride better
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
