|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-08-2006, 10:30 PM
|
#1 |
|
Senior Member
Join Date: May 2004
Location: Caldwell,Tx.
Posts: 3,648
|
Quarter panel question ?
I am going to replace one driver side bed side and have a question . I know that there is seam sealer where the bed and quarter panel meet right now . My question is .... do you bolt the panel on and then apply the sealer to keep water from seeping in from the top or does there need to be sealer between the panels before bolting them together . The quarter panel I have does not appear to have any sealer where the two panels meet , only a bead around the top side. I thought that there was some sealer between the panels . Also , what sealer do you recommend for this ? Frank
__________________
Born and proudly residing in a Red State ! Last edited by f.monroe; 04-08-2006 at 10:31 PM. |
|
|
|
04-08-2006, 10:36 PM
|
#2 |
|
Senior Member
Join Date: Dec 2004
Location: Southern Pines NC
Posts: 3,853
|
Re: Quarter panel question ?
you need to protect the metal between the 2 parts. Seam sealer will only keep water from sitting in the gag
|
|
|
|
|
04-08-2006, 10:38 PM
|
#3 |
|
Sb 400 club
Join Date: Nov 2005
Location: NH / MA
Posts: 2,746
|
Re: Quarter panel question ?
like the old fender welting they used in the 40's? what would one use now, a compund or felt???
__________________
 1984 chevy c10, built 400sb,.(SOLD )77 K10 Project / daily driver "The Grinch" http://67-72chevytrucks.com/vboard/s...d.php?t=318363 1956 Willys Wagon (327 chevy) Project (Now Buick 225) 1980 Corvette L-48 4 speed 1992 Mustang GT built 5.0 5 speed  1985 C10 LWB Sold 1982 K10 SWB plow truck Parted out 1986 D30 M1028 fire brush truck Parted out |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
