Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
08-14-2006, 12:30 PM | #1 |
Registered User
Join Date: Oct 2005
Location: San Diego, Ca
Posts: 251
|
Shifting noise when I stop and then go???
When I firmly press the brakes at say 10mph everything stops great. But I feel a shifting somewhere under the driver seat and towards the the fender well. It shifts again when I take off.
Is this a clue to the ultimate demise of my Rockers???
__________________
Rob "RunTMCfan" |
08-14-2006, 11:23 PM | #2 |
what happened to flint mi
Join Date: Oct 2005
Location: san diego
Posts: 437
|
Re: Shifting noise when I stop and then go???
run i would jack it up with jack stands under both the axles , start it up and put your foot firmly on the brake and then put it into drive let the brake out and slightly press the accelerator and then press the brake again and try to feel if it is still shifting , you could have a buddy look around down there while doing this to see if anything seems irregular. check your motor mounts and trans mounts too as well as spring perches . but really its hard to tell with out driving the vehicle 1st hand
__________________
71 swb 2wd fleet frame off in progress 72 4x4 blazer daily driver 70 olds cutlass s mint condition owned by a grandma 56 gmc 2wd project waitng 97 fiance mobile |
08-15-2006, 12:12 PM | #3 |
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Shifting noise when I stop and then go???
i'd check the cab mounts could be rusted or broken or the rubber mounts have rotted to nothing causing the cab to shift
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
08-15-2006, 01:09 PM | #4 |
Registered User
Join Date: Oct 2005
Location: San Diego, Ca
Posts: 251
|
Re: Shifting noise when I stop and then go???
Motor is tight. I could be the cab mounts. I have not done the fronts yet.
__________________
Rob "RunTMCfan" |
08-16-2006, 10:04 PM | #5 |
what happened to flint mi
Join Date: Oct 2005
Location: san diego
Posts: 437
|
Re: Shifting noise when I stop and then go???
oh i saw one of your posts about body mounts i thought you did all of them so i ruled those out .
__________________
71 swb 2wd fleet frame off in progress 72 4x4 blazer daily driver 70 olds cutlass s mint condition owned by a grandma 56 gmc 2wd project waitng 97 fiance mobile |
08-17-2006, 07:21 AM | #6 |
Senior Member
Join Date: Jun 2001
Location: Shelbyville, KY
Posts: 3,269
|
Re: Shifting noise when I stop and then go???
HOld your foot hard on the brake while the truck is in gear, then rev it enough to torque the engine and trans. Do this a couple of times and the problem will become obvious when the thing comes apart!hehehehehe--Don't do this in a garage or while parked behind your local police car. I suspect motor mounts, trans mount or spring mount issue. Was a common problem way back when.
|
08-17-2006, 10:08 PM | #7 |
Registered User
Join Date: Oct 2005
Location: San Diego, Ca
Posts: 251
|
Re: Shifting noise when I stop and then go???
Thanks guys. Good advice huck.
__________________
Rob "RunTMCfan" |
08-18-2006, 06:13 PM | #8 |
Registered User
Join Date: May 2003
Location: Saskatoon, SK
Posts: 44
|
Re: Shifting noise when I stop and then go???
Sounds a lot like mine at one point - a bad trans mount that eventially led to a loose crossmember
|
08-21-2006, 04:15 PM | #9 |
Registered User
Join Date: Oct 2002
Location: California
Posts: 27
|
Re: Shifting noise when I stop and then go???
Check your upper control arm shims. I have seen many of come out and have that exact problem
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|