|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-12-2007, 02:26 PM
|
#1 |
|
Weekend Warrior
Join Date: Oct 2004
Location: CT
Posts: 1,787
|
What are you guys doing about the rust on the inner bedsides??? - Picts inside
How have you guys been handling this situation - I know that it is pretty common for these trucks. Luckily the P.O. drilled about 50 1/8" holes under the rear wheel arch - so the outers didn't rust, but the inner panels where it attaches to the wheel house are a little "soft"
What would you do? This is the Driver's side rear (the worst of it - the pass side only has a couple small holes that can be patched pretty easy) 
__________________
-'07 GMC Sierra K2500HD -'66 C10 Suburban -'68/'71 K20 Service Bed Project -'69 Chevy C30 Mason Dump -'33Ford P/U 396ChevyPowered   
Last edited by arkracing; 03-12-2007 at 02:27 PM. |
|
|
|
03-13-2007, 08:28 AM
|
#2 |
|
Weekend Warrior
Join Date: Oct 2004
Location: CT
Posts: 1,787
|
Re: What are you guys doing about the rust on the inner bedsides??? - Picts inside
What nobody's had this problem?
Did you make a patch? - and how did you do it?
__________________
-'07 GMC Sierra K2500HD -'66 C10 Suburban -'68/'71 K20 Service Bed Project -'69 Chevy C30 Mason Dump -'33Ford P/U 396ChevyPowered
Last edited by arkracing; 03-13-2007 at 08:28 AM. |
|
|
|
|
03-13-2007, 08:34 AM
|
#3 |
|
Senior Member
Join Date: Oct 2006
Location: Edmonton Alberta
Posts: 458
|
Re: What are you guys doing about the rust on the inner bedsides??? - Picts inside
i had to cut out a piece of a boxside that was not rusted on the inside, but was no good on the outside
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
